The Short Answer
A full 8×4 ft MDF board in Pakistan runs from about PKR 1,500 for a thin 6mm sheet to PKR 9,000+ for a thick 25mm or laminated board. The single biggest driver is thickness, followed by grade (standard vs moisture-resistant) and brand. The table below gives the real per-thickness ranges seen across the market in 2026.
Cost by Thickness (Standard MDF, 8×4 ft)
| Thickness | Price per board | ≈ per sqft | Typical use |
|---|---|---|---|
| 6mm | PKR 1,500 – 2,500 | ~47–78 | Back panels, lamination backing |
| 9mm | PKR 2,000 – 3,000 | ~63–94 | Light panelling, drawer bottoms |
| 12mm | PKR 2,500 – 4,000 | ~78–125 | Shelving, cabinet parts |
| 18mm | PKR 3,500 – 5,500 | ~110–172 | Wardrobes, carcasses, doors |
| 25mm | PKR 6,000 – 9,000 | ~188–281 | Worktops, heavy shelving |
MR (moisture-resistant) MDF costs more than standard of the same thickness, and laminated / HPL-faced or UV-high-gloss boards more again — an 18mm laminated board can reach PKR 9,500. Local brands (Lasani, ZRK, KMI) tend to hold steadier prices than imported stock, which swings with the rupee. See our MDF board buyer's guide for grades explained.
How Many Boards Will You Need? (Worked Example)
Board count is where budgets go wrong, so here's a realistic example. A standard 6ft × 7ft two-door wardrobe typically works out at:
- Carcass, shelves & doors — 18mm: about 3 boards. At PKR 3,500–5,500 each that's roughly PKR 10,500–16,500.
- Back panel — 6mm: 1 board, roughly PKR 1,500–2,500.
- Indicative material total: PKR 12,000–19,000 for the boards, before laminate/veneer facing, edge banding, hardware and carpentry.
Scale up from there: a full kitchen's base and wall units can run 8–12 boards, and built-in TV or study units 2–4. Facing (laminate or veneer), hinges, handles and the carpenter's labour are all on top of the board cost — for furniture, the boards are usually only 30–45% of the finished price.
How to Buy Smart
Three quick ways to keep the cost down: buy full boards rather than off-cuts where you can (better per-sqft value), match the thickness to the job (there's no point paying for 18mm where 12mm will do a shelf), and choose a stable local brand if the rupee is moving. If you're laminating on site, remember to budget separately for lamination sheets or order pre-laminated board.